A3T 1913 Rear Adapter - AKM
- Machined from 6061 aluminum
- Low-gloss black anodize
- All bolt-on applications except for AK pistol
- Built-in Picatinny rail
A3 Tactical has a variety of rear adapters for all of the AK variants. For your specific AK model, please see details below:
|
ARSENAL SAM 7K Machined from 6061 T6 aluminum and anodized in low gloss black, this rear stock adapter securely mounts to the rear of your ARSENAL SAM7K with a single 1/4" screw through the rear QD hole on the trunnion. This adapter allows the use of our full line of modular stocks and braces on your SAM7K pistol. Simple 5 minute installation. |
 |
|
KALASHNIKOV KP9 This rear Picatinny (1913) adapter fits the Kalishnikov KP-9, KP-104, and KR-103 SFS. The adapter fits into the factory hinge pocket and converts it to a Picatinny rail. This allows the user to mount any brace or stock designed for Picatinny (1913) mounting. Machined from 6061 aluminum and hardcoat anodized low-gloss black. Made in the USA! |
 |
|
YUGO AK Machined from 6061 T6 aluminum and anodized in low gloss black, this rear stock adapter securely mounts to the rear of your YUGO style AK. These AK's have a pocket in the rear of the receiver. This adapter allows the use of our full line of modular stocks and braces on your AK, or any brace/stock designed to mount to a Picatinny style interface. Simple 5 minute installation. |
 |
|
AKM Machined from 6061 T6 aluminum and anodized in low gloss black, this rear stock adapter securely mounts to the rear of your AKM-style rifle and stamped steel AK47's. Works with factory tang, no need to modify your weapon. Does not fit milled receivers, Chinese receivers, or any slant-cut receivers. This adapter allows the use of our full line of modular stocks on your AK, or any stock designed to mount to a Picatinny style interface. Simple 5 minute installation. |
 |
|
AK PISTOL This rear Picatinny (1913) adapter fits AK pistols such as the Century Arms Draco and NAK-9, Chiappa PAK-9, and any AK pistol with a flat back and receiver width no greater than 1.360". For all flat back receivers, installation requires a .315" hole to be drilled in the rear back plate. Some receivers already have a quick-disconnect (QD) socket on the rear and will not require drilling. Machined from 6061 aluminum. Unique design has a center locating lug to positively locate the adapter vertically, and side guides to prevent the adapter from rotating. Adapter is threaded and secured by a large 1/4" screw. Made in the USA! |
 |
